Selection Of Rubber Gasket
Sep 25, 2019
The rubber gasket is suitable for mediums such as water, seawater, air, inert gas, alkali, salt aqueous solution, but not resistant to mineral oil and non-polar solvent. The long-term use temperature is lower than 70 °C, the use temperature is not more than 90 °C, and the temperature is low. Excellent performance, can be used at 60 ° C
Dingqing rubber gaskets are suitable for petroleum products, such as petroleum, lubricating oil, fuel oil, etc. The long-term use temperature is 120 °C, such as 150'C in hot oil and 1010201C in low temperature.
Neoprene gasket is suitable for seawater, weak acid, weak alkali and salt solution. It has excellent resistance to oxygen and ozone. Its oil resistance is second to that of rubber and it is excellent for other general-purpose rubber. The long-term use temperature is lower than 90 °C, and the use temperature is not more than At 130 ° C, the low temperature is 30-50 ° C.
There are many varieties of fluororubber gaskets, which have good acid and oxidation resistance and oil and solvent resistance. It can be used in almost all acid media as well as some oils and solvents, and the long-term use temperature is lower than 200 °C.
The rubber sheet is used as a flange gasket, and is used for pipes or hand holes that are frequently disassembled, and the pressure is not more than 1. 568 MPa.
Because in various types of gaskets, the rubber gasket is soft and has good bonding performance, and the sealing effect can be exerted under a small preload. For this reason, when subjected to internal pressure, it is easily squeezed out due to the thick or weak hardness of the gasket.
The rubber material is used in organic solvents such as benzene, ketone, and ether, and is prone to swelling, weight gain, softening, and stickiness, resulting in seal failure. Generally, the degree of swelling exceeds 30% and cannot be used.
In the case of low pressure (especially below 0.6 MPa) and vacuum, it is more suitable to use a rubber gasket. The rubber material has good compactness and a vacuum of 1.3 × 10-1 Pa. When the rubber mat is used in the vacuum range of 10p-1'10-3Pa, it needs to be baked and evacuated.







