Drain Pipe Rubber Sealing Ring Installation Method

Step 1: Turn over the installation position of the sink and place it, press and hold the sink, trace the outline along the edge, take it away and draw a cutting line on the inside of the outline for cutting

Step 2: Insert the head of the soap dispenser into the round hole of the sink, tighten it with a nut, and then screw the bottle body

Step 3: Insert the faucet into the round hole and fix the faucet with a simple installer

Step 4: After fixing the faucet, place the two faucet inlet pipes on the faucet, pay attention to the location of the hot and cold water pipes

Step 5: Put the drainer into the drain hole of the sink, and screw on the water sealing umbrella

Step 6: Apply sealant to the edge of the overflow, stick the silicone seal to the edge of the overflow

Step 7: After the sealing ring is firmly fixed on the overflow, apply a layer of sealant on the edge of the overflow

Step 8: Align the overflow with the overflow hole of the sink and glue it on, pay attention to align with the screw hole of the overflow

Step 9: Use a Phillips screwdriver to tighten the screws at the overflow hole to reinforce the overflow

Step 10: Apply sealant around the incision of the sink, put the front edge of the installed sink close to the front edge of the incision and cover the glue, then slowly lay the sink flat

Step 11: Put the silicone seal into the connection of the small water pipe

Step 12: Tighten the down pipe and link it to the drain

Step 13: Put the silicone sealing ring into the connection between the downpipe and the downpipe and tighten the hose

Step Fourteen: Insert the overflow pipe into the downpipe and tighten it

Step 15: Connect the drain hose to the drain.